As a contractor, I am in the process of putting my 3rd system in on new houses. The first we used the wells. One for each ton of the system. That is the most spendy way to go, but is still probably the best. On the next one, we went to the slinky system. Again, one loop for each ton. That is what we will use on this one we are building now. We hired the digging for the trench and put the loops in our selves. Total cost of the 3 loops was right at $1000. That included the piping, trenching, and the manifold and circulation pump. If you use the slinky lines, make sure the soil is in good contact with the tubes. Try to keep lumps out. Some guys put water in the trenches to settle it in good. That's what the guy wants on his system this time. The government is giving a 30% tax credit for a system. Our state also gives a property tax reduction. Local electric company will loan up to $10,000 for the cost at 5% interest. They also give a rate reduction for electricity used, about half. You will need two electric panels and a seperate meter to get that. They are saying about a 5 year payback. We are using the 2 stage pumps which are a little bit spendier but run cheaper. It runs so quiet you hardly can hear it. About like standing next to a refrigerator. Try to get the manifold inside the house rather that buried outside. If you need to shut down one loop you can from inside but if it's buried your out of luck. Make sure you insulate the lines in the house real good as they will sweat in the winter. We also hook it into the water heater to get free hot water.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.