Tractor Talk Discussion Board |
Re: OT, can't remember my geometry, need formula
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by suptscottyb on August 03, 2007 at 17:11:47 from (207.200.116.13):
In Reply to: OT, can't remember my geometry, need formula posted by Leroy on August 03, 2007 at 14:46:41:
New homes aren't the simple boxes they used to be. So often when laying out a foundation you'll have 4 or 5 boxes you need to square up. A simple way is to use the 3-4-5 formula. A right triangle -(one half of the square)- with one side 3' the other side 4' has a diagonal of 5'. Any muiltiplication of the 3-4-5 works. Use it in inches to hundreds of feet. It makes it quick and easy to line out...btdt. p.s. you don't have to measure at the corners to be certain you're square enough to dig... leave the exact diagonal math to the formsetters. Besides when you check your diag. lines, it will be the same measurement when square either way - whatever it is. Hope this helps more than not...
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|