Tractor Talk Discussion Board |
Re: ford PTO popping out
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BLW on April 17, 2007 at 06:19:54 from (4.156.33.22):
In Reply to: Re: ford PTO popping out posted by RodInNS on April 16, 2007 at 08:53:51:
rod-- I thought this was a 9N but when I took the pto shaft out it is splined not the old paddle type I'm used to/ so I think it might be a 2N or the whole pto has been changed, but I doubt that-- it does have the mag down in the front like the old 9N-- I have to get back to the barn and find the serial # so I can tell just model it is-- if it is that snap ring can it be put in from the top or does the tractor have to be split thanks bruce
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|