Tractor Talk Discussion Board |
Re: IH 350 Utility fast hitch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 20, 2007 at 08:33:14 from (66.173.50.71):
In Reply to: IH 350 Utility fast hitch posted by Al McNamara on January 20, 2007 at 07:01:30:
The hitch and components will lift 6 to 7 thousand pounds at the point of the standard drawbar insert into the hitch. (it will bend the drawbar into a "U" shape easily) We pulled a 60 foot deep driven well with our 350U. directly out of the ground. We pulled so hard that the tires on the rear were smashed down to 1/2 their normal height. (don't do this, it was probably very unsafe) I would say it would be fine to put 800 pounds on it without grief at all. It is much more powerful than this, and stronger. Doing this will also take stress off of the steering system. Keep your wt. close to the back axle, do not let it stick out much it will hit things when turning and backing. Go for it. JimN
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|