Tractor Talk Discussion Board |
OT - Carbon Arc sytem for welder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rex in Australia on October 19, 2006 at 02:17:38 from (59.100.20.37):
Hi, just on the off chance that one of you fellas may be able to help me. I have a twin carbon arc system that attaches to my welder to give an electric arc (flame) at the point. It is good for heating steel or even brazing etc as I do not own an oxy/acetylene system. Trouble is that I can not seem to track down any rods. I tried the normal carbon rods that are used for arc/air cutting etc and they just won't hold an arc when used together. I am told that I need +ve and -ve charged carbon rods. Similar to what was used in the old film projection units. Is anyone aware of a supplier of this type of thing? I would love to be able to use the tool again. Thanks from the land down under God Bless, Rex
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|