Tractor Talk Discussion Board |
Just got done building a lift for a tractor.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by old on September 29, 2006 at 17:06:39 from (4.245.0.242):
Thanks to Rod, I built a lift for the front of a tractor, Allis C and it works nice. It could be also made to work on almost any tractor that has hyds on it and isn't all that hard to build. I used one stick of 2X2X1/4 angle iron. About 10 foot of 1/4 falt iron and some round stock for pins. This lift could be use to lift blades/snow plows and or just plain lift things that are way to heavy for a person to pick up. Ya I know pictures would be nice but I have got that far yet. Just figured some one else might like to know how to make one. Thanks again Rod for showing me the picture so I could build this one
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|