Tractor Talk Discussion Board |
O.T. Ford 351 winsor engine problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dairyman on April 13, 2006 at 19:22:18 from (164.107.89.66):
A friend has a Ford 351 engine that will not crank over with the starter or by hand. The engine was taken apart to replace seals. There was no bottem end work done on the engine. When the engine was put back in the truck it cranked over slow so but we could crank it over by hand. after putting a new starter on the engine would not crank at all and acted like it was locked up. We removed the sparkplugs thinking that the head gasket failed and that the engine had gotten water in the cylinders, but when the sparkplugs were removed the engine still would not crank over either by hand or with the starter. Any suggestions as to what the problem is would be greatly apperciated. The engine is out of a 1976 Ford.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|