Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

You can have too much - it's rare though


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by jdemaris on March 10, 2006 at 05:54:26 from (66.218.18.44):

In Reply to: Batteries, can you have too many amps? posted by Tim B from MA on March 09, 2006 at 16:28:06:

Just about in all situations, bigger is better. You're not going to push more amps into a starter no matter what you do, but you WILL raise the voltage. There is a direct relationship between voltage and cranking-RPM.
Most 12 volt systems use a starter-motor designed to operate at 9-10- volts, so what we call a 12 volt starter is designed to operate at 9-10. In just about all cases that I'm acquainted with, starters are overbuilt and work fine if overvolted. Especially 6 volt starters hooked to 12 volts. But . . . I have had a few occasisons where a 12 volt starter would self-destruct with too much battery.
For example- I have a 1964 SS Chevelle with a high-compression 327 engine. Back in the late 70s, I found it almost impossible to get it started either when the engine was hot, or the weather was cold. I then found a place selling high-torque reworked Delco starters - so I bought one. It worked much better. Now, since I worked at a Deere dealership, we always had old-but-good batteries laying around that I got for nothing. One winter day, the temp. went down to -35 degrees F, and the car wouldn't start. So, I had the bright idea of putting in two huge tractor batteries in the trunk, hooked in parallel, along with 00 cables. Well, the starter spun amazingly fast. Also, it engaged very fast - almost to the point it sounded destructive. The next cold morning, I went out to start it - this time it was -20 F, and at first it spun pretty fast, then the starter-drive blew to pieces. This started a go-around with the company I got it from. Ends up, they told me to check cranking voltage. I did, it was 11 volts. They said it would not hold together at the higher voltage and warranty was voided. Afterwards, I tried several different types of heavy-duty starter drives, but they all failed - one way or the other. I finally gave up, and went back to one automotive-sized 700 CCA battery. I also stopped driving the car in the winter - which was a stupid thing to do anyway.
I realize that today, there's much better stuff on the market. I can probably buy a Chinese or Japanese made high-torque, gear-reduction starter and use all the battery I want. My point here is not to start an argument - like I said, problems from oversized batteries are rare. But, it can happen, and with more battery you might lower the amperage, not increase it, but the voltage, engagement, and cranking speed will go up.


Replies:




Add a Reply

:
:
:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy