Tractor Talk Discussion Board |
Re: routing heated hose
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by I Bleed Green on October 16, 2004 at 11:09:41 from (65.54.98.111):
In Reply to: routing heated hose posted by benny on October 16, 2004 at 08:15:26:
I will tell you how i have them hooked up on my 4020 Gas. I have a Hiniker 900 cab. I will start with the engine heater. The (cold) hose i have by the engine block drain. The (hot) hose should be in the head. I used the place where the bypass pipe connector goes into the head. I put a 5 or 6 inch nipple there with a tee at the top. I used a hose in place of the bypass pipe. For the cab (cold) I put a nipple and tee by the radiator drain. For the (hot) i drilled and tapped (3/8" pipe tap) one of the thermostat housings. I think a 3020 only has 1 of them. A 4020 has 2.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|