Tractor Talk Discussion Board |
Re: Hydraulic press cylinder
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rhudson on December 11, 2003 at 10:28:15 from (12.43.219.254):
In Reply to: Hydraulic press cylinder posted by Roy Suomi on December 10, 2003 at 20:52:31:
as others have said: if they are plumbed in parr. the force will be doubled and speed of extension will be cut in half. (assuming that the relief valve was not bypassing before you added the second cylinder). usually cylinders are connected in series when you need both cylinders to expend at the same rates with unequal loads. (there are several ways to ensure this with different series setups) as a note, in the parr. setup, just because the two cylinders are the same size does not mean that the cylinders will expend at the same time or rate. even a few pounds more force or friction on one cylinder will ensure that its twin will extend first. you will need mechanical structure to synconize the two cylinders.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|