Tractor Talk Discussion Board |
Broken distributor housing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve Shelton on December 21, 2002 at 13:24:03 from (12.93.63.201):
I bought a dist. kit and a video and went to work rebuilding the dist. Everything seemed to be going fine, even got a test light and checked the points for open/close, and shorts. All "OK". Put the dist. back on the tractor and tried to start it and was getting no spark. Pulled the Dist. again and noticed that the dist. cap was partially pushed off. Inside, the rotor was messed up and had gouged the inside of the dist. cap. I figure the little tabs on the Dist. hadn't lined up with the slots inside the engine housing, but the dist. seemed to go on fine when I put it on. Now I have a crack in the cast distributor housing. Can I buy the houseing without having to buy the entire distributor? Steve S.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|