Tractor Talk Discussion Board |
Delco Remy Cutout Relay specifications needed
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bobduck on July 15, 2002 at 14:00:11 from (209.206.226.174):
Working on my Oliver 70 - the Cutout Relay on generator. Cutout points weren't closing and discovered there was rust preventing them from closing. Cleaned the rust out so the Cutout now works but had to disassemble the Cutout to do the cleaning. Would now like to correctly set the "Air Gap" and "point gap" and "closing voltage" range but can't find the specifications. Generator is a Delco Remy six volt and the Cutout on the generator is #1116809. Anyone out there have this information? Thanks in advance. Bobduck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|