Posted by Leroy on June 19, 2022 at 08:01:50 from (98.30.20.69):
In Reply to: Re: Uncrimped hay posted by Bruce from Can. on June 18, 2022 at 14:41:35:
I made hat for years and cannot understand that. NO WAY does a crimper or crusher make short pieces. Either type just makes the stem more flexiable. I have had different crimpers and crushers and you can tell handling a bale if it was unconditioned or conditioned. Now if your hay is a soft stem like lawn grass it is different. We had alfalfa, red clover and tinithey. If that ctimped stem is easier on your hand when you pick up the bale it naturaly would be easirt on the cows mouth. Used 2 different type crimper rolls, and 2 sifferent crushers before got a mower-conditioner. And at times we would go back over the swath a second time with a conditioner. And we did have a tedder and used it a lot. Now if you are talking a flail type conditioner that I have never seen that could make short pieces like running the hay rhru a flail forage harvester like used for green chopping. Those flails are a knife so I can see that making short pieces but NOT a normal crimper or crusher. A crimper has like coragated steel roller runing together to break the stems at intervilles from every 1 inch up to every 2 inches while a crusher id like two smooth rollers running together and just mashing the steem breaking both sides. So neither can make short pieces. I believe if you could have a bale of each of a conditioned and one of unconditioned hay, exactly same hay the coes would take the conditioned bale first over the unconditioned bale for one reason and that is easier to get in their mouth.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.