Tractor Talk Discussion Board |
Re: Farmall A Brushhog????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rich3 on June 13, 2007 at 10:54:10 from (74.60.110.90):
In Reply to: Farmall A Brushhog???? posted by JimN on June 11, 2007 at 06:43:49:
You need near 20 PTO HP to pull a 5 ft brush hog through heavy grass/brush, An A is under that (15 PTO HP) . A 4 ft would be OK . I have a similar sized tractor and I have a 4 1/2 ft model and at times I use a 1.5 MPH gear. An A does not have that luxury of that low a gear. Independant PTO is not a issue, just use an overriding clutch on the PTO shaft, even with IND PTO you still need that overide clutch as it will try to push you when you try to stop or change gears.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|