Posted by JB JIM on April 18, 2018 at 04:25:57 from (50.105.73.195):
Ignition switch question: I have an old Ranch King tractor tug and the keyed ignition switch went to "dead switch" heaven so I went to Tractor Supply and bought a universal ignition switch w/ keys. Upon opening the packaging I put the key in the switch and tried to see if it worked smoothly - it didn't. In fact it will not move from anyone position to another. I took it back to tractor supply and the gentleman said he knowledge of things electrical was nill=good luck.!!!! Before I dig the old switch out of the control deck can someone advise if the switch needs to be electrically charged (installed) before it can be moved before the key can move it from one position to another? My knowledge is about the same as The TSC fellow...Thanks and I expect to get some heckling over this lack of knowledge..jb
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.