Maybe it's just me, and paranoia takes over, but I was always afraid of using an old oil filter on anything. Even ones I had purchased and forgot to use or misplaced only to find it later. I was concerned that the element may have decomposed and might come apart. No, never seen it happen, but I have had old lawnmower filters start coming apart on the shelf in my shop. Might have been bugs or something helping as well.
On old oil, sounds good to me, as long as it's kinda stirred a bit. Moving it around would do that. That's another thing too. I had some old cardboard oil cans that started leaking while sitting on the back of a shelf in an old freezer that had been used for storage. Freezer didn't work any more....Maybe some condensation helped it along, but it sure was a mess by the time it was discovered.
I also found a case of LPS lubricant in aerosol cans that had all lost their pressure. After making sure there was indeed no pressure in the cans, I drilled holes in the bottom and drained them so I could still get the oil out of them. Put it in mason jars and later used it in little squeeze type oil cans with spouts on them.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.