Posted by RodInNS on July 31, 2013 at 19:10:02 from (216.118.158.123):
In Reply to: NH 273 manual needed posted by Tractormiallis on July 31, 2013 at 18:44:42:
If you don't turn up a used one you can call any NH dealer and get a reprint in ~2 weeks for probably less than 40 bucks. Only thing the knotters need is grease. 1-2 pumps on each nipple. Should be 6-7 on each side of the knotter. Remember... modesty is important when greasing a knotter. 1-2 shots is plenty... Beyond that there's probably a couple on the needle frame, couple more on the knotter bell crank/drive and the rest would be on any drive line crosses or shaft telescopic points....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.