Posted by rust-o on January 25, 2013 at 14:52:48 from (184.108.40.206):
Hi, I recently bought a Massey 165 that didnt have Aux Hydaulics and being that i plan on running a haybine i needed hydaulics on it. So i bought a kit for putting hydaulics on it. It came today but didnt have any directions for installation. I didnt figure i would need instructions for mounting the valve, but i wasnt sure if it was neccesary to bleed the hoses etc.
Does anybody have any tips for doing this?
anything in particular i need to know to do this?
hoping to work on it tomorow so any advice is greatly appreciated!
Also how much Hydraulic fluid is needed to raise the level from add to full?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.