Pull carpet back. One way to get the "old" look, is to start out with a 1 inch, or 5/4 base board (if you are using 3/4 wainscoat) say a 1x4 or 1x6 and set your 3/4 boards on top of the base. Set your base on 3/8 blocks, (remove after install) and the carpet layer will tuck underneath base. Glue is fine, but if you have access to a trim nailer, you can toe-nail the edge of the tongue on a 45 to hold them in place till the glue dries.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.