A steel supplier won't give you advice on the size of an I beam you need. I think the cost of hiring an engineer to look at it would be better spent in steel. A I-beam is realitively cheap. If you have the means of handling it a 10" or 12" I-beam should handle anything. I put a 10-26 I-beam 20' in a house to hold up a second story. I had a engineer give the recomendation on that one. I also built a bridge on my property which span 24' with 2 12" I-beams which I've been driving vehicles over for years. The beams were less than $200.00 each. As far as handling it a 10"-26 I-beam weights 26 pounds per lin ft.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.