Posted by JDseller on October 05, 2012 at 21:13:03 from (208.126.196.144):
I have 10-15 log chains that get used to tie down things being hauled or just needing a pull. I have them hanging on a rack that keeps them sorted. The problem I have been having the last 4-5 years it the darn liquid calcium that the state is using to keep the roads clear. It just rusts the chains terrible. Not big flaking rust but makes them real nasty to handle.
I had a guy that delivered some things a while back that had painted all of his chains. He said that he just would spray paint them when he bought them. Yes they get chipped where you hook them but the rest was real clean and rust free. So I wanted to do it to mine.
I started out with one and just washed it off in some paint thinner. Then I painted it with spray paint. It looked good for about a week them the paint fell off. I looked and the rust under that paint did not let the paint bond to the steel.
I was wondering about using Electrolysis to clean them up. Would it work?? I was thinking about using a twenty gallon kitchen garbage can. Put a steel plate with a wire in the bottom. Then make a rack to hold the chain in loops across the inside of the can. Would this clean them back to bare steel??
If I can get them relatively rust free I am going to try dip painting them. I just want them so you can handle them without looking like you fell in a rusty barrel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.