Posted by GUIDO on January 06, 2012 at 12:56:50 from (71.168.205.231):
Hello George Marsh, I was referring to Ni-Cads batteries. If zapping the pack did not work, you need to get in the pack and check for a weak cell, or lose connection. If a cell has been hot and vented it will look like this one on the picture. It will then have to be replaced. Check all the cells individually, and then you can zap any that not charging properly. You will need a (lINEAR) constant voltage charger with the ability to adjust current-amperage without overcharging the cell. You also should monitor voltage while doing it so as you don't exceed 2 volts, Also if you can check the temperature of the cell, I would not go over 110 degrees F. or you will risk venting the cell. Hope this helps you. Let me know how you make out. Guido
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.