Posted by CB in central NY on September 19, 2011 at 08:49:54 from (216.81.94.73):
I"ll make it as short as I can.
1994 Toyota 1/2-ton pickup, 4x4, 157,000 miles. The rear differential housing rusted through and leaks (previously repaired, new leak). Pinion seal also sprang a leak, did not see it at first.
The other day wife was driving truck home. All of a sudden the rear end locked up on her (dragged the tires in a skid). Long story short, diff. case empty, smoking hot. Rear end locked up, won"t move in neutral.
We got some 90 oil, put it in. After a while diff. loosened up. She drove it home, grinding noise coming from diff. case.
Next day I replaced pinion seal, drained case, looked inside. No apparent broken parts, everything seems to be moving smoothly (did not take diff. assembly out yet). I put it back together, took it for a drive. Grinding noise still there, truck also seems to lack power accelerating uphill. Grinding noise also increases when truck is allowed to coast (as opposed to the gas pedal being depressed)
I am thinking that a bearing (or multiple bearings) is damaged. I am also wondering if when the truck locked up, it could have damaged the clutch or the transmission. I am going to tear into the rear axle (probably the only way to find out what is damaged), and I am looking for advice from folks who might have had a similar situation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.