Posted by dave2 on August 21, 2011 at 03:03:32 from (79.240.133.132):
OK folks,
Got two on the way. Do they come with instructions and/or are they dummyproof? Can rent a small backhoe for a hundred bucks a day and get a guy with it for another hundred. I need a 90 ft by 1 meter deep ditch so will come out cheaper than or equal to the 100 bucks by having them just send someone to dig it for me and go home in a couple hours.
Want to run one line with a hydrant at the end and one T'd in at the beginning. Do I need to leave them accessable or just use 3ft or so of rigid pipe for each and cement them in (only 3ft bury)? Was thinking of a 2ft x2ft by 4 or 6 inch slap at each with a piece of pipe (PVC?) just big enough for the hydrant pipe to slip thru. That way if I have to replace something I can reuse the slab.
Also, would putting foam insulation tubes around the line serve any purpose in the case of an extra cold winter? How long does temps have to be below freezing (15 degrees f is real cold for my area and we may get that for 3 weeks then 25 to freezing all in about 8 -10 weeks)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.