Posted by downsouth on July 17, 2011 at 21:19:48 from (64.12.116.74):
When I first got goats, I was hauling water out to the pens to fill the tanks. Then I wised up and installed an outside hydrant on the back of the well house (closest place to the goats I had water) so I could just drag a hose out there. Well that's 150 feet and honestly I was getting darn tired of dragging that much hose once a week. So I decided it was time to dig a ditch and run a water line a bit closer. Not having a trencher, nor the money to rent one I decided to utilize what I have. I have a root cutter and a middle buster for my Ford, so I had at it. As you know, when trying to dig a ditch in this manner, the dirt tends to fall back in the ditch. At least I do own a drain spade (bill dookie) so I was able to clean the ditch out, but dang with this heat index of 107 it makes it some mighty tough work for an old guy.
.
. As you can see I borrowed the wifes pop up canopy to make myself some shade of the area of the ditch I was having the clean out. You have to appreciate any shade you can get when it get's this darn hot
. I also had to set a post to mount the water hydrant to, so out came the post hole digger.
. There we go, 3 feet deep. That should do it. BTW, our frost line might be 2 inches during a bad winter, so not much to worry with. The ditch is 18 inches deep which will keep the water line from breaking under the worst of circumstances here.
. And I got the post set and braced and began running the PVC. Didn't finish up until after dark so I never got any more pics but once completed I turned the water on and no leaks. Makes for a good end to the weekend. Of course, now I still have to cover the ditch, UHG!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.