Posted by Will- Tx.-Mn. on July 07, 2011 at 17:18:54 from (76.187.191.229):
In Reply to: 40x60 Steel Building posted by kswillie on July 07, 2011 at 16:42:50:
I did a Rihno steel building back in 2006, erected it for my employer, the erectors were me, my brother and brother in law.. it was 30' X 100'
it was my first, we got it done took us a whole month, there were hardly any directions but we got it done, and it didn't leak when it rained..
and just this past May, down the road another contractor errected two simular buildings and bigger, I told him what I did and how long it took me ( a whole month) and he said Rihno is the worst, so I reckon I did well considering.....
this was in Texas, and in August (hottest month) so perhaps this gives you a little to go by.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.