Posted by State of Jefferson on April 05, 2012 at 08:51:09 from (22.214.171.124):
In Reply to: Gooseneck Hitch posted by njfarmer on April 03, 2012 at 19:07:42:
I've made several of my own. 8"x3/4" plate bolted to 1/2" angle iron, bolted to the frame. Drill hole in center of plate for shank of ball, nut welded to bottom of plate, use a pipe wrench to take ball on and off.
That being said, if I were gonna buy one, I'd go B&W.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.