Posted by cumminspuller on July 20, 2011 at 06:34:28 from (65.83.65.34):
In Reply to: Ford Engine swap posted by Keith-OR on June 22, 2011 at 12:35:56:
I would not do this swap either. Even with the bad milage of the 460 you will run circles around the 7.3. Good motors just not a big power house. If you do deside to do this then you may look at Painless wiring. They may possibly have a harness that will plug in with little modification. I understand you not wanting to put a lot of money in a truck you only put 4k miles a year on. IF it were me doing the swap it would get a cummins. Either a rotary pump or a p-pump motor. both of those with a few mods will out do a big block gasser with no problems. Milage as well as power and reliabilty.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.