Yes they should lock the brakes, even with a moderate load. I would suspect out of adjustment since you say there is 12v at the wheel. Did you check volage between the wires or just frame to hot? Trailer brakes need to be adjusted tighter than most people think. Adjust them up til they drag a bit then back off JUST till they turn free. You should still hear a bit of rubbing. To check the magnets jack up each wheel and spin the wheel and have someone hit the controller, they should grab and stop right away. Another thing to check is wireing. If they are grounded to the frame rather than a wire to the front you may want to redo them. I usually just buy an electrical cord and cut the ends and use that for the brakes. Run it right from the plug to the axles.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.