Posted by JOB on October 06, 2013 at 10:21:37 from (173.84.197.160):
I have a truck hoist that I am working on. This is a rough drawing of the hoist, and mine is not made exactly like I have drawn it. The pin at point C is froze up, so I have cut the hoist apart and am in the process of making a new pin and sleeve or bushing whichever it is called. At points A and D there is roughly .060 thousands clearance between the pipe and the round stock that goes into the pipe. That .060 could be from wear; this hoist is far from new. Point B I can not measure for you can not get it apart because it is not necessary. There is quite a bit of clearance at point B though. The yoke at the end of the cylinder should have been drawn with dotted lines for it is inside the frame work. All the pipe used on the hoist appear to be schedule 40.
Does anyone know how much clearance is at these points or does it really matter? I was planning on putting .030 to .040 thousands at point C. Any thoughts?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.