Posted by CGA55 on September 17, 2013 at 09:52:27 from (173.209.204.229):
This message is a reply to an archived post by Glenn Bork on July 31, 2011 at 19:42:46. The original subject was "Re: What has happened?".
Hey guys, never used a forum before, so not sure how to post yet. Anyways, I just bought an 881, driving it to the farm it did great, 28 miles without any trouble except it never got into 10th gear. Then, 300 yards before the gate on a pave it finally went into 10th nd abruptly died, skidded at the end and now won't start, go into neutral, and when trying to pull it, R/H rear wheel wants to turn in reverse, opposite the L/H wheel!? I've got the 3 set manual ordered, assume the S-O-S cable let-go, safety featute shut fuel off, and rear end pin sheared. Of course I have no clue. Any ideas or experience with this sort of scenario? I'd appreciate any input, especially if there's anyway to get her into a neutral condition so I can tow her home without damaging her any more...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.