Posted by RayP(MI) on August 28, 2013 at 14:09:11 from (184.108.40.206):
Older Whirlpool gas dryer converted to propane. Ignitor cycles properly, (recently replaced with newer "M" style.). Ignitor sensor switching properly. Appears that valve is not opening when ignitor switches off. Sometimes gas comes on and burns for 30 seconds or so. Then goes back off. I have one voltmeter across the ignitor sensor, and it is reading properly - Voltage when switch open (ignitor hot) - no votage when switch closed (ignitor cold). Volt meter on incoming wires to valve/ignitor/sensor is showing voltage, indicating that upline thermostats are conducting. This would mean the valve or the solonoids are not working properly? New soloniod coils run about $90, and I don"t want to know what the valve AND solonoid coils cost...
(Got a feeling this is going to cost me a NEW washer AND dryer before this all plays out.)
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.