B&D and John Thanks for your replies. I pretty much under stand how they work now.
I have another question for you. Another person posted a link to a steel sliding breaker block that would make it where you could not have the mains and dedicated generator breaker on at the same time. Would one of these be good enough???
The house in question is on city water and has all gas heat, cooking, and water heater. So we would be just talking about needing lights, frig, and the furnace fan in winter.
I do have a plug and box that has a MALE 220 volt plug mounted in it. ( weatherproof box too) I have not seem one like it around. But I was thinking about wiring it as the supply for the generator. This could be hard wired into a box on the side of the house. Then you would just need a short cord between this and the generator.
With the interlock setup the male ends would never be "hot" Which is why I never have used this box before.
I kind of like the sliding interlock deal in that it would be cheaper but even better you could change what you powered just by flipping different breakers. This way a smaller generator could be used.
Example: You have maybe a 5000 watt generator. You run your light and frig. Then after you go to bed your freezer and the frig.
Just thinking you would have a lot of flex ability with this over the dedicated circuit deal.
We have looked at the automatic systems. They just switch a few circuits. So you are stuck with just those things being powered.
The farm has a automatic system on a stand by Generator that can run everything. It is great but not cheap.
Where we are thinking about this setup having it switch automatically is not needed. If they are not home they do not need the things to switch over by themselves right now. Maybe later but trying to keep the cost down for now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.