Posted by Billy Shafer on July 26, 2013 at 10:39:02 from (173.184.71.178):
In Reply to: Re: Generator problem posted by Stick welding on July 26, 2013 at 07:23:30:
Yes he could have. Then the insurance man would have come out. Seen the plug say sorry. You are own your on.
I have been working with generators since 1968. I can"t tell you how many times I have seen. People trying to bypass the correct way to supply power. I have walked off more than one job. Because the customer wanted me to make do with what he had. Always tell them. I do it correctly or I don"t do it.
Saw one man burn down half his house trying the plug thing. Insurance agent called me out to the site. He arrived saw where the generator was plugged into. Told the owner sorry insurance canceled,improper generator installation.
Listen to us that know. Not Billy Bob down the street. Do a correct installation or forget it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.