Posted by mick in il. on July 02, 2013 at 04:08:53 from (108.69.179.61):
In Reply to: Splicing 4/0 feeder posted by awlknottedup on June 30, 2013 at 17:22:22:
Just like a couple of others have said, go to a reputable electrical shop and buy direct bury splice kits. They'll come with a butt splice (usually they have screws to tighten) and two shrink wraps, one long, one short. Clean the wire, slide both heat shrinks on, use your butt splice good and tight, slide the shorter of the two heat shrinks on and heat it then follow on top with the long one and heat it on. Then let cool and bury, no problem. Key with aluminum is make sure it's CLEAN! Good Luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.