Most digital multimeters do not measure true RMS voltage. Also, all transformers introduce a certain amount of harmonic distortion. This distortion is called hysteresis or "crossover distortion" and will result in a different peak voltage for a given RMS voltage than the nominal 1.4 ratio. So it's not uncommon to get a measurement error when reading a transformer's output using a typical peak-averaging multimeter.
However, you haven't been particularly forthcoming about your actual setup. As Bob and John T pointed out, if you are reading the DC output of a rectified AC signal, the voltage is not going to be the same as the RMS voltage but will rather be the PEAK voltage of the signal. For a 24 volt rms sine wave, the peak voltage is around 34 volts. It's details like this you need to understand before trying to roll your own battery charger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.