Posted by Lanse on April 12, 2013 at 08:40:00 from (206.55.217.126):
Hey everyone!!
So, this is one of my newest videos...
As y'all know, I've been exploring my interest in welding cast iron lately, and after running a few different stick welding methods, I turned my focus to Mig Welding...
I just wanted to try something a little bit different, so I got a spool of 308L Stainless-Steel wire, .030" diameter, and tried it out welding up a cracked cast iron exhaust manifold off a V6, and I was pleasantly surprised at how well it turned out...
What I did, was to "Veeee" out the "crack" in the manifold, and then I preheated it with a rosebud until it was just starting to glow... It didnt take long, a thinner casting with a lot of exposed surface area like this will heat up, and cool down, more rapidly than other things, so I gave it a few seconds of "cooling time" while I shut down the torch and grabbed the mig gun...
That wire ran REALLY well... It sounded great, had a very controllable puddle, and even looked pretty nice when it was done.... I'm very happy with how it came out...
Anyway, just thought I'd share the video, and I hope y'all are doing well, I'm just getting over being sick, lol... Anyway, have a nice (early) weekend, everyone!! :)
Audio/Video clip:video1
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.