rockyridgefarm said: (quoted from post at 09:19:58 03/15/13) Hey all,
Alls I got on the farm right now is a leaking old 10 gallon Montgomery ward 2 cylinder compressor. It works ok, but it sure take a long time to air up an 18.4-38 and forget about using an air impact or blowing off even a small piece of equipment.
Guys got a 60 gallon (he thinks) air compressor that's set to run on 240 for sale on CL. He says it takes four minutes from empty to 125 psi. I'm looking for a decent compressor to run an impact wrench, air up tires, and such. He wants $300. Should I bite?
Pictures are decieving but it looks smaller than 60. Take this formula with you though, you will need it anyway to get an accurate cfm rating.
1 gallon is 231 cubic inches.
The volume of a cylinder is given by volume = 3.1415 times radius squared times height. With that you can have a pretty accurate measurment of the tank size in gallons. Or, if you have a phone with you that has internet access, you can just punch in the numbers here: http://aqua.ucdavis.edu/calculations/Volume_of_a_Cylindrical_Tank.htm
When I punched in your numbers, it came out to 9.57 CFM. Keep in mind that CFM changes depending on pressure. The only way to find out at the pressure you want is to do the calculations near the pressure you want. Check from 30-50 if you want the 40psi CFM rating or check from 80-100 if you want the 90psi CFM rating. If you are going to check it before you buy it, it wouldnt hurt to take a known accurate gauge with you that can be plugged in to the line.
I just went through this math stuff a little while ago when I bought a used compressor that was made in the lying years for ratings. Now with the new ones I think they still lie but with the HP ratings, not the CFM as much.
This post was edited by Rich_WI at 20:27:19 03/15/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.