Posted by MarkB_MI on February 25, 2013 at 02:29:39 from (75.219.14.38):
In Reply to: Ground for a welder posted by Stan in Oly, WA on February 25, 2013 at 00:10:45:
Stan, that's a great question. I had to think about it a bit. I don't think there is much of a safety issue, but there is a definite possibility you could damage the shop's ground system.
Most likely, the combined resistance of the circuit will be high enough to limit the current through the ground and just give you a weak arc. For example, if there's 10 ohms total resistance, you won't get more than 8 amps, which isn't going to damage anything. But let's say you have a particularly good ground, or you connect your work lead directly to a ground rod or a pipe that's bonded to ground. Now the current is limited only by what the welder can put out. The circuit you've created is unfused, which means the fuse is the whatever is the weakest link in the circuit. That might be a ground wire, a terminal connection or maybe your arc. If your arc isn't the weak link, somthing else is likely to blow.
The thing to remember is that the ground circuit is designed to carry enough current to fault the largest breaker in the panel, but only for long enough to trip the breaker. A six gauge wire can easily handle a 100 amps for several seconds, but it can't handle it indefinitely. And there are other things in the circuit, such as screw terminals and receptacle contacts that could suffer arc damage.
My recommendation is you don't do it. I think the risk of damaging the ground circuit is small but significant.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.