Posted by State of Jefferson on February 05, 2013 at 21:04:25 from (220.127.116.11):
In Reply to: dust extractor posted by hd6gtom on February 05, 2013 at 15:01:28:
My little 2hp singl stage collector isn't doing the job in my shop anymore. I was going to get a single stage collector of about 4-5 hp, but after a bit of investigation, I think I'm going to go with a slightly smaller cyclone collector. Likely from Grizzly. I think it will be a better fit... I have several pieces of Grizzly equipment and am pleased with it. I have a Biessemier fence on my old 3hp Grizzly saw and sure like it. When I upgrade my saw I'm going to go with a Sawstop. Like the other's have said, its a whole lot cheaper than a trip to the hospital! Have heard they are a very good quality saw to boot!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.