Posted by Stick welding on January 12, 2013 at 18:36:03 from (96.53.210.246):
In Reply to: Some people... posted by Don-Wi on January 11, 2013 at 20:00:21:
I worked at a job where that was very adamant about reporting safety issues or potential safety issues. That is until my boss fell about 8 ft. off a beam trying to put a tarp on a roof in a wind storm. I was the welding supervisor and he knew I wasn't letting him keep it quiet. I heard later that he confessed to another long term employee that he broke his arm. He did admit to me that he scared himself pretty good. He landed about 3 ft. from the edge of some scaffolding below the roof narrowly missing the pin sticking up to attach more scaffolding. Had he missed the scaffolding, he would have fell to his death about 30 ft. below. I think if this was reported would have shut the place down pending an investigation. I think he got a real wake up call trying to be a show off!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.