Posted by George Marsh on December 28, 2012 at 03:55:10 from (220.127.116.11):
In Reply to: Shop floor posted by Wade1984 on December 27, 2012 at 19:03:10:
A friend and concrete finisher put my 6 inch floor down, 30x40. Used my self leveling rotating laser, found a spot where the laser just hit the bottom of overhead door. Then put a 16p nail in every post where the beam hit. Only had to use one form board at the overhead door, which we drilled holes in for re-bar to connect the slab to the apron. Friend used a Georgia buggy to truck the concrete inside the barn. Concrete finisher doesn't like fiberglass. We used wire and cure and seal sealer. Day later he cut the lines in floor. 4 years later and no cracks.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.