Posted by Puddles on December 28, 2012 at 02:53:43 from (24.113.77.208):
In Reply to: Shop floor posted by Wade1984 on December 27, 2012 at 19:03:10:
Had an engineer tell me one time that there is absolutely no structural value in concrete mesh, all it does is hold the concrete together after it breaks.
Few things I had done for my shop floor, at each door opening I went with a thickened edge. I dug a 12” wide by 12” deep trench.
On each side of the 6” x 12” posts the concrete crew nailed HTT-16 clips to tie the slab to the post. But one time I seen a set of blue prints for a pole barn there was a detail for drilling a hole through the posts and sticking a # 4 bar through the hole and bending it back at about 45 degrees into the slab area with about 3-feet long tails.
Do yourself a big favor, don't forget expansion joints!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
