Posted by JRSutton on December 11, 2012 at 13:56:50 from (75.130.109.233):
In Reply to: Removing Ceramic Tile posted by Dick J on December 10, 2012 at 10:37:09:
You can rent a power hammer/scraper and blast all the tile off.
You should be able to get it pretty smooth that way. A good beltsander with some 40/60 grit emery will flatten anything left (use a good respirator).
If it's a small bathroom - it's a lot of work, but doable.
If it were me - I'd take a skilsaw, set the blade to 3/8 depth with a demo blade and criss cross that plywood and just peel it all up.
REAL pain the but - but if you want to to things right and set a floor that'll outlast you, that's the way to go.
Yyou should then use 3/8 cement board set in thinset - tape the seams.
whatever you do, remember floor height is important - don't do the 1/4" on top of the 3/8 plywood. 1/4" doesn't sound like a lot - but it is. The floor will look and feel real thick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.