Posted by jon f mn on November 29, 2012 at 11:51:41 from (220.127.116.11):
In Reply to: Re: MIG wire feed posted by George Marsh on November 29, 2012 at 11:41:09:
All my welders get a piece of felt folded over the wire and held on with one of those wide metal paper clips. I put a little oil on it, mostly to attract the dust and dirt on the wire. It works good for me. I don't think it does anything as far as lube, there is not enough on there for that. All the Miller welders I bought new came with that in them. Not in the Lincolns tho.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.