Algar, I've had that happen to me with the Miller TIG welder. I would tap the foot pedal and unless I went all the way and back up to where I wanted it wouldn't start. This was when I was first learning how to TIG in the Coast Guard. The DC2 that was teaching me claimed it was an illusion, and I was developing a bad habit. We had a different miller with different gas for stainless, and I never had the problem with that one, and when I used the thumb control, I never had that problem, either. I always suspect that it was the pedal. Over time I noticed it not happening, but I also noticed that there was a new pedal. The DC2 swares I just became more proficient while using the thumb control, but to this day, I think the pedal was bad, and I am pretty sure he knew it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.