Lanse, I welded some cast with 6011 twenty five years ago and it's still holding. It's the casting that comes off the top of the radiator on a 630 deere. The muffler bolts to it. I tried brazing,I tried nickel, both of them ran off like water, probably due to poor surface prep, my fault. So out of desperation I started in with 6011, peening after every pass. No pre-heating. That tractor was used every day as a loader tractor up until ten years ago, then every other day till two years ago, and it hasn't broken yet. But I haven't driven under any more low doors to test it either!!!! Jim
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.