Posted by Stick welding on November 18, 2012 at 18:04:39 from (96.53.210.246):
In Reply to: Workin on the BBQ... posted by Lanse on November 18, 2012 at 12:31:43:
Curious why you put the trim around the fire box and why you didn't use your MIG welder, especially on the big gap? 6010 overhead is NOT fun. I would have either made the BBQ portion first and put the undercarriage on after or tried to reposition the whole thing so I didn't have to weld overhead. It looks like if you had an engine crane, you could have stood the whole thing up on the fire box to make welding it easier. That's why big shops spend thousands on welding positioners or move large pieces into the flat or horizontal position. It saves a lot of time and makes it easier for the welders to do their best work. I built a lot of big skids and we would stand them on their side for horizontal welding and then flip upside down so we didn't have to weld them overhead. It saved a lot time and BURNS.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.