Posted by dennis min on November 03, 2012 at 13:45:30 from (220.127.116.11):
I bought a small lathe and want forward and reverse motor operation from it. The motor is an EICOR, which doesn't seem to follow any standards for terminations. The terminals are labelled one through 6, with nothing on 6, just a hole in the area a stud would be. Perhaps other here could shed some light.
The motor is running off 120v single phase just fine in forward.
Any help to locate what I've got and where to go is appreciated.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.