Lanse: I already have two newer Miller welders: A 251 and a 252. The Miller 252 is only about three years old an I have already had to replace the circuit board in it once. This is with light shop use not full time welding.
This welder is supposed to have only been used a few times. The seller's Dad bought it new and only used it a few times. The seller has used it on some heavier frame type repairs but his main business ins auto body work and he uses welder that are setup for thinner metal.
I am looking for an old wire welder without all of the electronics that the new welders have on them. I think that these Miller 35 welders do not have any electronics on them. All is diodes and rectifiers. I am not sure of this but that is what I want.
A long gone buddy had a Miller 35 that he used in his weld shop for years and he never had any problems.
That new Hobart welder has that new welder smell but it also is full of electronic crap that can take a dump and become a big paper weight. LOL
Thanks for the reply. I am really looking for some of the older guys that actually ran these welders. I want a good welder on 1/8 to 3/8 thick stuff. I have good stick welders for thicker stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.